Protective coatings that buy time when it matters.
Fire-retardant and intumescent coatings for interior and exterior surfaces — specified to the job, applied to the manufacturer’s system, and prepared properly underneath.
Fire-Retardant Coatings · MelbourneFireproof Painting Melbourne – Fire-Retardant & Intumescent Coatings
A fire-retardant coating will not make a building fireproof. What it does is slow things down — and in a fire, time is the thing that matters most.
PCS VIC applies fire-retardant and intumescent coating systems to interior and exterior surfaces across Melbourne, as part of the same painting work we already do. Same preparation standards, same crew, and straight advice about whether you actually need it.
What a Fire-Retardant Coating Actually Does
Intumescent coatings are designed to react to heat rather than simply resist it.
- Under high heat the coating swells to many times its applied thickness
- That expansion forms an insulating char layer across the surface
- The char slows heat reaching the material underneath
- Ignition and surface flame spread are delayed
The honest version: it buys minutes — and minutes are what let people get out and the fire brigade get in.
Where It Gets Used
Most of the enquiries we take are for:
- Exposed structural and decorative timber
- Timber decks, eaves, pergolas and external cladding
- Internal linings and plasterboard
- Exposed steelwork
- Properties in or near bushfire-prone areas
Common reasons people call
- A building surveyor or insurer has asked for it
- A renovation exposed timber that now needs protecting
- Peace of mind on a family home
How We Apply It
A fire-retardant coating only performs if it goes on the way the manufacturer intended. That makes it a measured job, not just a paint job.
- Assess the substrate and confirm what the coating is being asked to do
- Full surface preparation — the coating bonds to whatever is underneath it
- Apply the specified undercoat at the required film thickness
- Finish with a compatible topcoat from the same system
- Record what was used, and where
Mixing products across brands, or going on too thin to save a coat, defeats the entire point of the product.
A coating is one layer of protection, not a compliance certificate. If your job needs certified fire performance, we will tell you that up front rather than after the invoice.
Where We Will Tell You to Get Someone Else
Some fire work is not a painting job, and we would rather lose the quote than take it on wrongly.
- Certified fire-resistance levels signed off for a building permit
- Passive fire systems — penetrations, collars, fire-rated sealing
- Fire doors, alarms, sprinklers and detection
If your job needs a certifier or a licensed passive fire contractor, we will say so and point you the right way.
Why Have PCS Do It
- The same preparation standard as the rest of our painting work
- One team, so prep, repairs and coating are not three separate bookings
- Straight advice on whether the coating is worth it for your property
- A written record of the system used and the areas covered
Start with a $99 Property Check
Not sure what actually needs protecting?
Our $99 check can identify:
- Exposed timber and unprotected surfaces
- Existing coatings that have failed or worn back
- Surface damage that needs fixing before any coating goes on
It is the cheapest way to find out whether this is a job worth doing.
Want to know if your property needs a fire-retardant coating?
Contact PCS VIC today for fire-retardant and intumescent coating work across Melbourne.
South Yarra · Richmond · Port Melbourne · Albert Park · Camberwell · Hawthorn · Kew · Tarneit · Truganina · Werribee